CHARACTERISTICS OF THE LOSA ELT17 FRAME
Model of 2017, also marketed in 2019
Frame Type Kit : Endurance
High quality materials. Use of unidirectional carbon fiber with high tensile strength Torayca® T800S. The material chosen contributes to increasing the impact resistance to avoid breakage of the frame.
Optimization of Driveability. The ELT17 model is equipped with a tapered headset: 1 “1/8 upper bearing, 1” 1/2 lower bearing. This solution guarantees an excellent driveability of the frame.
Mixed comfort stiffness. The geometries of the ELT17 model have been developed to make the parts where the transfer of power between the runner and the frame rigid in order to minimize energy waste. The frame has also been designed to make even the rider’s comfort optimal.
Very low weight. The geometries of the ELT17 model have been developed to minimize the weight of the frame without detracting from safety. The weight of the rough frame size M (50cm) is only 860 gr.
Top aerodynamics. The ELT17 project was born with the concept of minimizing the resistant impact of the air flow on the frame. The optimization of the aerodynamics of the ELT17 model goes through the full inner cable technology and the design of the tubes.
Design and elegant liveries. The design of the ELT17 model is based on the elegance of the shapes and the liveries have been designed to enhance their shapes through the combination of geometries and colors.
Warranty on the frame kit extended to 5 years. The high quality standard of the frame kit allows us to extend the standard warranty provided by the Law.
- Material: Full Carbon Torayca® T800S
- Lay-up (fiber direction): UD (Unidirectional)
- Weight of the rough frame: 860 gr. (Size M)
- Weight of the raw fork: 380 gr.
- Measurements: 5 size (44cm, 47cm, 50cm, 54cm, 58cm)
- Tapered headset: 1 “1/8 upper bearing, 1” 1/2 lower bearing
- Bottom Bracket: BB86
- Groupset: traditional Shimano or DI2
Mode of supply
1) Frame kit in standard sizes 2-color painted with standard livery consisting of
- Headset 11/8 “-11/2”
- Internal DI2 fixing
2) Complete racing bike tested
Frame kit made in China assembled by our technicians with the models shown below and tested to guarantee quality
The Bike Test ELT17